Snap a photo — see what it is, how urgent, who to call.
One photo of the problem. fixRAgent reads it and gives you a Triage Profile.
Triage a photo nowNo sign-up.
No — this code is not a fault. If it smells like burning, sparks, or trips the breaker, switch it off at the breaker and leave it off until it is checked.
Take the photo. We’ll tell you what it is.
No sign-up · AR Logic LLC · Privacy
Managing this for someone else? Managers: set it up for your buildings →
Managing this for someone else? There is a version of this for whole portfolios.
Managers: set it up for your buildings →“Items were detected in the washer during the Clean Washer cycle.”
— Maytag (Whirlpool Corporation), Error Codes in Front Load Washers. Codes vary by model: check your washer’s own manual.
The same code can also show as: F34.
Next to rL in Maytag’s table: Int (The cycle was paused or canceled) and Sud (There are too many suds in the washing machine).
Safety: If it smells like burning, sparks, or trips the breaker, switch it off at the breaker and leave it off until it is checked.
At least WHENEVER. This code is a mode, a reminder or a status message rather than a fault. It does not need a repair on its own. This is fixRAgent’s reading, not the manufacturer’s. A photo can raise it — water near wiring, scorch marks, a gas smell — but a code never lowers what the photo shows.
Appliance repair. Have the model and serial numbers from the label ready — a photo of the label works.
Check whether your model is under a safety recall on the U.S. Consumer Product Safety Commission’s site: cpsc.gov/Recalls. Your owner’s manual is on Maytag’s support site; search it with the model number from the label.