Snap a photo — see what it is, how urgent, who to call.
One photo of the problem. fixRAgent reads it and gives you a Triage Profile.
Triage a photo nowNo sign-up.
Usually not an emergency. If it smells like burning, sparks, or trips the breaker, switch it off at the breaker and leave it off until it is checked.
Take the photo. We’ll tell you what it is.
No sign-up · AR Logic LLC · Privacy
Managing this for someone else? Managers: set it up for your buildings →
Managing this for someone else? There is a version of this for whole portfolios.
Managers: set it up for your buildings →“the door is not closed properly”
— LG USA, LG Front Load Washer - Error Code List(New). Codes vary by model: check your washer’s own manual.
The same code can also show as: dE, E01.
In plain words, dE1 is about the door or lid lock — the control cannot confirm the door is shut and locked (or unlocked).
LG gives 2 other door or lock codes for this washer: dE2 (the door is closed but not locked), dE3 (the lid is not properly latched).
Next to dE1 in LG’s table: tCL (high time to run the tub clean cycle) and dE2 (the door is closed but not locked).
Safety: If it smells like burning, sparks, or trips the breaker, switch it off at the breaker and leave it off until it is checked.
At least THIS WEEK. fixRAgent treats this code as a this-week repair: the appliance has reported a fault, but the code alone does not point at a safety hazard. This is fixRAgent’s reading, not the manufacturer’s. A photo can raise it — water near wiring, scorch marks, a gas smell — but a code never lowers what the photo shows.
Appliance repair. Have the model and serial numbers from the label ready — a photo of the label works.
Check whether your model is under a safety recall on the U.S. Consumer Product Safety Commission’s site: cpsc.gov/Recalls. Your owner’s manual is on LG’s support site; search it with the model number from the label.