Rheem gas water heater: error code T105
What it means, in Rheem’s own words, how urgent it is, and who to call.
Show us the water heater.
Snap a photo — see what it is, how urgent, who to call. One photo of the problem. fixRAgent reads it and gives you a Triage Profile.
Is T105 on a Rheem gas water heater an emergency? No — this code is not a fault. If you smell gas, do not touch switches or try to relight anything: leave, and call the gas utility or 911 from outside.
Or start with a sentence
Property manager? Set this up for all your buildings →
AR Logic LLC · Privacy
Everything about T105
What T105 means
“Water Leak Sensor Not Installed”
— Rheem, Rheem Residential Super High Efficiency gas water heater Use & Care manual (AP21831 Rev 2), alarm and alert codes. Codes vary by model: check your gas water heater’s own manual.
Where T105 fits
In plain words, T105 is about water where it should not be — the machine has sensed a leak or an overfill and stopped.
Rheem gives one other leak code for this gas water heater: A104 (Water Leak Detected).
Next to T105 in Rheem’s table: A104 (Water Leak Detected) and A110 (Shutoff Valve Test Close Error).
What to try first
- Check the leak sensor is in the bottom pan and connected.
Safety first
If you smell gas, do not touch switches or try to relight anything: leave, and call the gas utility or 911 from outside.
How urgent is it?
At least WHENEVER. This code is a mode, a reminder or a status message rather than a fault. It does not need a repair on its own. This is fixRAgent’s reading, not the manufacturer’s. A photo can raise it — water near wiring, scorch marks, a gas smell — but a code never lowers what the photo shows.
Who to call
Plumber. Have the model and serial numbers from the label ready — a photo of the label works.
Questions people ask
What does T105 mean on a Rheem gas water heater?
Rheem’s own support material (Rheem Residential Super High Efficiency gas water heater Use & Care manual (AP21831 Rev 2), alarm and alert codes) says: “Water Leak Sensor Not Installed”
Is T105 on a Rheem gas water heater an emergency?
No — this code is not a fault. If you smell gas, do not touch switches or try to relight anything: leave, and call the gas utility or 911 from outside.
Who do I call for T105?
Usually: Plumber. Check the leak sensor is in the bottom pan and connected.
Recalls and manuals
Check whether your model is under a safety recall on the U.S. Consumer Product Safety Commission’s site: cpsc.gov/Recalls. Your owner’s manual is on Rheem’s support site; search it with the model number from the label.
Related codes

Not sure it is the code?
Snap a photo of the display and the model label. The Triage Profile says what it is, how urgent it is, and who to call.